Downloads
Release Notes - v1.2 (build 113)
Node Firmware Updates:
- Added support for SHA-256 Encrypted Wireless Network support using user-defined passphrases
- Added ability to shut down a node to preserve battery charge whilst in storage
- Fixed issue to accurately measure Sensor Node’s battery charge, regardless of the battery’s state of charge
- Fixed issue that caused Sensor Node capture to miss data samples
- Enhanced RF performance for throughput and interference resilience
- Applied improvements to significantly enhance overall system performance
- Applied improvements to display Node state using LEDs when Resetting or Erasing Nodes
Configuration App Updates:
- Added ability to set passphrases for SHA-256 Encrypted Wireless Network support
- Added Node Shut Down command to preserve battery charge whilst in storage
Previous Build - v1.1 (build 112):
Version: v1.1 Release Build: 112 File Size: 41.3 MB – Download
Node Firmware Updates:
- Fixed issue to prevent invalid time data to be used to set Sensor Node clock
- Fixed issue to accurately record capture time for each measurement, relative to the UTC start time
- Fixed issue to accurately measure Sensor Node’s battery charge, note that this requires a full discharge/charge cycle for calibration
- Added measure to track battery charge/discharge cycles to monitor battery health and aging
- Added support for adjusting how often Sensor Nodes require time sync signals during capture
- Added support for separating Wireless Networks by RF channel
- Enhanced RF performance for throughput and interference resilience
Configuration App Updates:
- Fixed mis-labelling issue with Accelerometer measurement units
- Added the ability to configure Wireless Networks operate on any of 4 distinct RF channels
- Added the ability to configure how often a Wireless Sensor Node requires a sync signal to continue capture
- Added the ability to view battery cycle count as a tool tip on the battery icon
- Added support for NIFI Strain Gauge Sensor Node functionality
- Changed the Direct Wireless Capture command to independently send start or stop capture signals
Previous Build - v1.0 (build 111):
Version: v1.0 Release Build: 111 File Size: 40.5 MB – Download
Node Firmware Updates:
- Added support for NIFI Strain Gauge Sensor Node functionality
- Support for NIFTI Accelerometer Node functionality
- Initial public release
Configuration App Updates:
- Initial public release
